Installation Sheet

Step 1. Insert the blades into the motor housing blade slots, push blade until it stops. You should

be able to hear the inside safety pin drop into the blade hole to secure the blade in place. (Fig. 7)

CAUTION: Re-check each blade to make sure all blades are secured to the locking mechanism by

holding the blade from the tip and gently pulling it outwards. The blades should be snug to the

motor housing without any up, down or sideways play.

All blade sets are grouped by weight. Because plastic injection varies in density, the fan may wobble

even though the blades are weight matched.

BLADE REMOVAL

In the event that the blades need to be removed, use the blade removal tool included with your fan.

Remove the two screws, washers and rubber covers from the motor housing. Remove the blades by

pulling the safety pin via the opening above the blade in the motor housing as shown.

IMPORTANT! Make sure to replace the rubber covers and screws. (Fig. 8)

BLADE INSTALLATION

Fig 7