Instructions / Assembly

5. Apply a thin coat of Polycrylic® with a high-quality synthetic bristle
brush. Apply in one direction with the grain. Do not overbrush.
6. Let dry at least 2 hours then sand with very fine sandpaper (220 grit) to
ensure an even finish and proper adhesion of additional coats. Do not
use steel wool. Remove all dust.
7. Apply second coat. For additional coats, repeat Step 6 before applying.
Three coats are recommended.
8. After final coat, allow 3 hours before light handling and 24 hours before
normal use.
Special Instructions: Polycrylic® should not be applied over red mahogany
stain. Instead, use Minwax® Fast-Drying Polyurethane or Minwax® Water
Based Oil-Modified Polyurethane over any red mahogany stain. Polycrylic® is
not recommended for use on floors because it would require more frequent
recoating in high traffic areas. Instead, we recommend any Minwax
polyurethane, including Minwax® Water Based Oil-Modified
Polyurethane or Minwax® Super Fast-Drying Polyurethane for Floors for
maximum durability.
CLEANUP: Clean with soap and warm water immediately after use.
COVERAGE: Approximately 125 sq. ft. per quart.
Notes: Thinning is not recommended. Keep from freezing. Store below 105°F.
For interior use only. Dry times are based on good ventilation, temperature of
77°F, and 50% relative humidity. Lower temperature, higher humidity, lack of
air movement or application of thick coats will extend drying times. Always test
surface for tackiness between coats. Oil-based stains, paints or coatings
applied under Polycrylic® may amber normally. Always spot test on an
inconspicuous area to ensure satisfactory results.