User Manual
APPENDIX A
WARNING 1: DIY mode is for advanced users only. Use it at
your own risk. If you don’t know what you’re doing, you risk
damaging your Nerotrigger.
WARNING 2: This port is already powered. This means that it
reads “999 ″
when there is no conne
n between the
sleeve and the tip. When the two are shorted, it reads “1 ″.
You can use this to create simple touch sensors, pressure
sensors, tilt sensors, etc. If you are planning to use external
sensors, you must keep DIY port voltage under a maximum
of 3V.
WARNING 3: You must use the following schematic to use
Nerotrigger at DIY mode.