Instructions / Assembly

PACKAGE CONTENTS + (6) Screws
BUILD THE TRELLIS WALL
Hold a 2ft. Board on the ground so it’s standing on edge with the notched ends to
the left and right. Slide a Trellis Post down over one notched end of the Board. Next,
slide another Trellis Post over the other notched end. This forms the Trellis wall.
BUILD TWO SHORT WALLS
Repeat Step One using Tall Posts to complete two more walls.
Questions? Email [e-mail] or call 800-622-5510 Monday - Friday 8am-5pm EST
BUILD A FRAME WITH TRELLIS ON ONE SIDE
Place the Trellis wall and one short wall parallel to each other and connect them
into a rectangle with two 4ft. Boards. This forms the frame of a 2ft. x 4ft. Garden
Bed with Trellis on one side.
MODEL #
RCMG2811TRE
DIMENSIONS
2ft. wide x 8ft. long
x 11in. high
12in. x 2.5in.
x 2.5in.
Tall Posts
x4
CEDAR RAISED GARDEN BED WITH TRELLIS | ASSEMBLY INSTRUCTIONS
1.
2.
3.
4ft. x 5.5in.
Boards
DECIDE WHERE YOU WANT THE TRELLIS AND BUILD
THE SECOND FRAME
The Trellis can go on either end of the garden bed, or in the center, depending on
where you attach the second 2ft. x 4ft frame. Once you decide, place the other
short wall from Step Two parallel to the correct wall and connect them into a
rectangle with two more 4 ft. Boards, completing a 2ft. x 8ft. rectangle.
4.
FINISH GARDEN BED WALLS
Add one more Board, one at a time, directly on top of each existing Board in the
frame. Push the Boards down evenly between the tops of the Posts. If needed, tap
snugly into place with a rubber mallet.
5.
3.5in. x 3.5in.
Decorative Caps
x2 x6 x8
x10
x20
x6
46.5in. x 2.5in.
x 2.5in.
Trellis Posts
2ft. x 5.5in.
Boards
2ft. x 1.25in.
Trellis Slats
Trellis
Spacers
BUILD THE TRELLIS
Slide one Spacer into the top of each Trellis Post, then add one Slat on top of the
Spacers and push them down directly on top of the existing wall.
Repeat Step Six using all the Spacers and Slats to complete the Trellis
6.