Installation Sheet

TOOLS NEEDED FOR ASSEMBLY
(not included)
Lock Nut and Screws
Metal Washer
Rubber Washer
Pipe
Hot
Flexible
Hose
Cold
Flexible
Hose
Steps to Complete Your Faucet Install
Hot Hose
O-Ring
Cold Hose
Pipe
Hot Hose
Lock Nut and Screws
Metal Washer
Rubber Washer
Cold Hose
Pipe
TROUBLESHOOTING TIPS
Finish is changing color or is shiny
Abrasive cleaners, soaps or other
factors constantly in contact with it.
Stop using abrasives; Replace parts
Issue Reason
New faucet needed; Tighten supply lines
Cracked casing inside; Supply lines
may be loose
Leaking from under the body
Remove ceramic cartridge, check for cracks
Tighten locking nut; Remove cartridge,
check for cracks
Lock nut has come loose; Ceramic
cartridge may be defective
Leakage under the handle
INSTALLATION INSTRUCTIONS:
SINGLE-HOLE FAUCET
Phillips
Cartridge may be defective
Water will not shut off completely
Solution
• Turn off water on both supply lines that connect to your faucet. These will
be located on the back wall underneath your sink.
• Screw the pipe onto the faucet and make sure the O-ring is on the faucet
base. Fasten the hot and cold flexible hoses into the bottom of the faucet
body if necessary.
• Carefully lower the faucet through the drilled hole.
• Slide the rubber washer and the 1.5-inch metal washer onto the pipe and
tighten the fastener.
• Attach the flexible hoses to the supply line sources. The flexible hose on the
right (when facing the sink) should be attached to the cold water line, and the
hose on the left will attach to the hot water line. Tighten these connections
accordingly.
• With the faucet lever wide open, slowly turn the handles on the hot and cold
water lines to the open position at your desired flow rate. Allow the faucet to
run for 10-15 seconds to clear any air remaining in the faucet.
Please note:
• Review and abide by all building and plumbing codes
• Standard codes for Miseno faucets: cUPC/CSA/AB1953
• Miseno faucets need to be installed by a professional or skilled do-it-yourselfer.
• A 1.5” faucet hole is required for installation
• Maximum counter thickness is 2”
Questions, problems, missing parts? Before returning to your retailer, call our
customer service department at 855.480.2915, 7am to 5pm PST, Monday-Friday,
or email us at [e-mail]