Troubleshooting guide

129
Maintenance
Power Down the Controller
To power down the MXe Server:
1. Shut down the controller operating system before turning off the power
switch by
• log in to the MSL shell and type “shutdown -h now”
OR
• start the Server Manager and shut down using the Reboot or
Shutdown panel.
2. Continue with the procedure, “To power down the controller, Release
7.0 and later:” below.
To power down the controller, Release 7.0 and later:
1. In the System Administration Tool, navigate to Maintenance
Commands.
2. Enter the Shutdown command.
3. Remove power:
- for the AX and MXe, set the power switch(es) to OFF
- for all other controllers, remove the power cord.
To power down the controller, prior to Release 7.0:
1. Type appShutdown at the RTC shell.
2. When the controller boots up, the communication program will instruct
you to Press
<SPACE><SPACE><SPACE> to stop auto-boot AFTER
countdown starts (Release 5.2 and later) or Press any key to stop
auto-boot (prior to Release 5.2).
3. Remove the power cord.
Perform a System Reset
To reset the system:
1. Log into the System Administration Tool (page 71).
2. In the Maintenance Commands form:
• Rel 7.0 and later, enter the reset system command, or
• Prior to Rel 7.0, enter the LOAD 1 command.