Troubleshooting guide

17
Initial Setup
Configure MAS Parameters
4. After the Server Console screen appears, you are prompted to accept
the End-User License Agreement. Select Accept.
5. In the configuration screens, select the following settings:
Table 3: MAS Configuration Parameters
Configuration Screen Required Setting
Restore from Backup (this screen
relates to a backup of the Linux
database)
Select No.
Choose Linux Admin Password Enter a password. Then, enter it again to
verify it. Note that passwords are
case-sensitive. Also, see Caution below
this table.
Select Primary Domain Name Enter name (for example mitel.com)
Select System Name Enter name (for example the company
name)
Enter Local Networking Parameters
(local IP address for this server)
Enter 192.168.1.8
(INITIALLY, KEEP AS DEFAULT!!!)
Select Local Subnet Mask (see Note
below)
Enter 255.255.255.0
Select Operating Mode Select Server-only
Select Gateway Address Enter 192.168.1.1 (INITIALLY, KEEP AS
DEFAULT!!!)
Set DHCP Server Configuration Select Off - Do not provide DHCP
Service to local Network
Corporate DNS Server Address Enter your corporate DNS server IP
address.
Application Record ID Leave field blank. Click Next.
Activate Configuration changes Select Yes
Note:Use 255.255.255.0 unless your network requires a different subnet
mask. If your network requires a different Local Subnet Mask, change it now.
You can only change the subnet mask through the server console. In the
MAS Server Manager application, the subnet mask is a read-only field.