Troubleshooting guide

Table Of Contents
55
Installation and Programming
CX II and CXi II
1. Position a mounting bracket inside the rack frame at the desired
height. Fasten the mounting bracket to the front of the rack frame with
two screws—one in the top hole, the other in the bottom (see
Figure 18). Then do the same to fasten the other mounting bracket on
the other side of the rack frame at the same height.
Figure 18: CX II/CXi II Controller Rack-Mount Installation - Attaching
Brackets to Rack Frame
2. Remove the cover from the controller.
3. Fasten the angle brackets on each side of the cabinet. Align the
brackets with the pre-drilled holes located near the front panel. Use
two screws to fasten each bracket (see Figure 19).
Figure 19: Figure 21: CX II/CXi II Controller Rack-Mount Installation
- Attaching Brackets to Controller