Specifications

(4) Separating the indoor unit to allow for easy transportation

The indoor unit can be separated into the base block, fan block, and other parts.

Place the unit on a level surface before separating the unit.

The dimension of the base block after it is separated from the other parts is

marked with ✻ in the figure below.

The above step completes the procedure.

Use caution not to damage or scratch the unit during transportation.

1) Take the following steps to separate the unit, referring to the figures below.

2) Reassemble the unit in the reverse order as above.

Replace all fixing screws and bolts back in, and tighten each of them to the proper tightening torque.

3) Items to be checked during test run

Check for abnormal sounds and water leakage after test run.

a. Remove the decoration panels 1 through 6 in that order.

b. Remove the fan block fixing screws located in the positions as shown in the figure, and pull the fan

block 7 forward to remove it.

Please note that the fan block on the P500 model weighs 118 kg[261 lbs] (P600-F model weighs 93kg[205 lbs].).

c. Remove the beam 8.

d. Remove the side panels 9 and

10 on the right and left.

Instructions for separating the P500, P600-F indoor unit into parts

635

1,420

1850 49

1160 706

✻✻

<Front>

Fan block fixing screws

(4 places in the front on both sides)

Net weight

Base block net weight

P500, P600-F

Fan block dimensions

Base block dimensions

(Side view

of the fan

case)

70kg[155lbs]

✻

P500-F model

units are not

equipped with

duct flange.

Unit:mm