Instruction manual

8
INSTALLATION AND WIRING (FR-A700/F700 SERIES)
2.3 Wiring
(1) Untwist the twisted pair shielded cables after stripping its sheath.
Also, perform protective treatment of the shield to ensure that it will not
make contact with the conductive area.
Strip off the sheath about the size as in the right figure. If the length of the
sheath pealed is too long, a short circuit may occur among neighboring
wires. If the length is too short, wires might come off.
Wire the stripped cable after twisting it to prevent it from becoming loose.
(Do not solder it.)
Use a bar type terminal as required.
REMARKS
• Information on bar terminals
Commercially available product examples (as of September, 2006)
Sheath
Shield
(perform protective treatment)
Twisted pair
shielded cable
Cable stripping size
6mm
Bar terminal crimping tool: CRIMPFOX ZA3 (Phoenix Contact Co., Ltd.)
Terminal
Screw Size
Wire Size
(mm
2
)
Bar Terminal Model
Maker
With insulation sleeve Without insulation sleeve
M3
0.3 to 0.5 Al 0,5-6WH A 0,5-6 Phoenix Contact
Co.,Ltd.
0.5 to 0.75 Al 0,75-6GY A 0,75-6
When using the bar terminal (without insulation sleeve),
use care so that the twisted wires do not come out.