Specifications

79
OBJECT MAP
7
7.8 Class 0x66 (Extended Object I)
7.8.1 Class 0x66 Instance 1
Set parameters of the inverter. Refer to the Instruction Manual of the inverter for details of the parameters.
(1) Attribute
REMARKS
• When reading/writing parameter, Class 0x70 to 0x79 (Extended object III) is recommended. (Refer to page 86)
Class 0x66 Instance 1
Attribute ID Parameters Access Name
10 Pr. 0 Get/Set Torque boost
11 Pr. 1 Get/Set Maximum frequency
12 Pr. 2 Get/Set Minimum frequency
13 Pr. 3 Get/Set Base frequency
14 Pr. 4 Get/Set
Multi-speed setting (high
speed)
15 Pr. 5 Get/Set
Multi-speed setting (middle
speed)
16 Pr. 6 Get/Set
Multi-speed setting (low speed)
17 Pr. 7 Get/Set Acceleration time
18 Pr. 8 Get/Set Deceleration time
19 Pr. 9 Get/Set Electronic thermal O/L relay
20 Pr. 10 Get/Set
DC injection brake operation
frequency
21 Pr. 11 Get/Set
DC injection brake operation
time
22 Pr. 12 Get/Set
DC injection brake operation
voltage
23 Pr. 13 Get/Set Starting frequency
24 Pr. 14 Get/Set Load pattern selection
25 Pr. 15 Get/Set Jog frequency
26 Pr. 16 Get/Set
Jog acceleration/deceleration
time
27 Pr. 17 Get/Set MRS input selection
28 Pr. 18 Get/Set
High speed maximum frequency
29 Pr. 19 Get/Set Base frequency voltage
30 Pr. 20 Get/Set
Acceleration/deceleration
reference frequency
31 Pr. 21 Get/Set
Acceleration/deceleration
time increments
32 Pr. 22 Get/Set
Stall prevention operation level
33 Pr. 23 Get/Set
Stall prevention operation
level compensation factor at
double speed
34 Pr. 24 Get/Set Multi-speed setting (speed 4)
35 Pr. 25 Get/Set Multi-speed setting (speed 5)
Class 0x66 Instance 1
Attribute ID Parameters Access Name