Specifications

84
OBJECT MAP
7.9 Class 0x67 (Extended Object II)
7.9.1 Class 0x67 Instance 1
Set parameters of the inverter. Refer to the Instruction Manual of the inverter for details of the parameters.
(1) Attribute
REMARKS
• When reading/writing parameter, Class 0x70 to 0x79 (Extended object III) is recommended. (Refer to page 86)
Attribute ID Parameters Access Name
10 Pr. 270 Get/Set
Stop-on contact control
selection
15 Pr. 275 Get/Set
Stop-on contact excitation
current low-speed
multiplying factor
16 Pr. 276 Get/Set
PWM carrier frequency at
stop-on contact
18 Pr. 278 Get/Set Brake opening frequency
19 Pr. 279 Get/Set Brake opening current
20 Pr. 280 Get/Set
Brake opening current
detection time
21 Pr. 281 Get/Set
Brake operation time at start
22 Pr. 282 Get/Set Brake operation frequency
23 Pr. 283 Get/Set
Brake operation time at stop
26 Pr. 286 Get/Set Droop gain
27 Pr. 287 Get/Set Droop filter time constant
38 Pr. 338 Get/Set
Communication operation
command source
39 Pr. 339 Get/Set
Communication speed
command source
40 Pr. 340 Get/Set
Communication startup
mode selection
42 Pr. 342 Get/Set
Communication EEPROM
write selection
45 Pr. 345 Get DeviceNet address
46 Pr. 346 Get DeviceNet baud rate
192 Pr. 500 Get/Set
Communication error
execution waiting time
193 Pr. 501 Get/Set
Communication error
occurrence count display
194 Pr. 502 Get/Set
Stop mode selection at
communication error
Attribute ID Parameters Access Name