Instruction manual

95
6
NETWORK VARIABLES
6.8.13 PID differential time (network input config SNVT_time_sec nciInvPIDDiffTm)
You can set the differential time of the PID control of the inverter.
To disable differential control, set "0.0s" or "6553.5".
⋅ Data acceptance timing....At network variable receive when the inverter is at a stop (nv_update_occurs event)
6.8.14 PID manipulated variable bias (0.1Hz increments)
(network input config SNVT_freq_hz nciInvPIDOpeBias)
You can set the manipulated variable of the inverter in 0.1Hz increments when the deviation (difference
between set point and measured value) under PID control is 0%.
⋅ Data acceptance timing..... At network variable receive (nv_update_occurs event)
Data Name Initial Value Range Increments
Setting Value
Storage Location
nciInvPIDDiffTm Initial value of Pr. 134 0.0s to 10.0s, 6553.5 0.1s/bit Pr. 134
REMARKS
• Refer to the inverter manual for use of PID control.
Data Name Initial Value Range Increments
Setting Value
Storage Location
nciInvPIDOpeBias Initial value of C2 (Pr. 902) 0.0Hz to 400.0Hz 0.1Hz/bit C2 (Pr. 902)
REMARKS
• Refer to the inverter manual for use of PID control and details of C2 (Pr. 902).