Instruction manual

98
NETWORK VARIABLES
zNetwork variables supported
The following network variables are subject to the receive interval time.
Function
Network Variables
In/Out
Refer to
Page
Variable Name
Start and stop/simple speed setting SNVT_switch nviDrvSpeedStpt In 48
Speed adjustment SNVT_lev_percent nviDrvSpeedScale In 49
Inverter input signal SNVT_state nviInvInputSig In 51
Set frequency (0.1Hz/bit) SNVT_freq_hz nviInvSetFreq In 56
Set frequency (0.005%/bit) SNVT_lev_percent nviInvSetFreqP In 56
PID set point (0.005%/bit) SNVT_lev_percent nviInvPIDTarget In 69
PID measured value (0.005%/bit) SNVT_lev_percent nviInvPIDValue In 70
PID deviation (0.005%/bit) SNVT_lev_percent nviInvPIDDev In 71
Set frequency (0.01Hz/bit) SNVT_count nviInvSetFreq2 In 76
REMARKS
• The communication line error detection is invalid when Pr. 502 Stop mode selection at communication error = "3".