Instruction manual

5
1
PRE-OPERATION INSTRUCTIONS
* TX LED turns on when the inverter autonomously sends data due to heartbeat and event driven function even when the
communication cable is not wired.
Name Function LED Status Status
L.RUN
Display the handshaking status
with the inverter.
ON Normal operation
OFF Alarm detection
RUN Display the unit operation status.
ON Normal operation
OFF Alarm (watchdog timer expiration etc.) detection
TX *
Display the transmission status
of packet to the network.
ON
(for about 50ms)
Transmitting
OFF Stop transmission
RX
Display the receiving status of
packet from the network.
ON
(for about 50ms)
Receiving
OFF Stop receiving
SERVICE
Display the status of node and
service switch.
ON Service switch pressed status
Flicker Unconfigured status
OFF Configured status
WINK
Display the receiving status of
WINK message from the
network.
Flicker three times Receiving WINK message
OFF Stop