Instruction manual

40
6 NETWORK VARIABLES
6.1 Object Map
This chapter describes detailed object definitions for use of LONWORKS system.
Inverter
basic
functions
Inverter PID
control
functions
Inverter
extended
functions
Configuration properties
Output network variables
Object request
Start/stop and simple speed setting
Speed adjustment
Inverter input signal
Set frequency write destination selection
Set frequency (0.1Hz/bit)
Set frequency (0.005%/bit)
Alarm reset
Emergency stop command
PID set point (0.005%/bit)
PID measured value (0.005%/bit)
PID deviation (0.005%/bit)
Monitor code
Set frequency (0.01Hz/bit)
Command request
Input network variables
Object status
Speed monitor
Inverter output signal
Output frequency monitor (0.1Hz/bit)
Output frequency monitor (0.005%/bit)
Output current monitor (0.1A/bit)
Output voltage monitor (0.1V/bit)
Actual operation time monitor (1h/bit)
Alarm status
Monitor data
Output frequency monitor (0.01Hz/bit)
Command reply
Node object
Inverter object
Variable Speed Motor Drive
object
Cumulative power monitor (1kWh/bit)
Cumulative power monitor 2 (0.1kWh/bit)
Emergency stop status
Alarm occurrence definition (string)
Product information(maker name,type)(string)