Instruction manual

44
NETWORK VARIABLES
*1 Displayed in 0.01 increments on the operation panel.
*2 Refer to the inverter manual for the corresponding parameter initial values.
*3 Values within parenthesis are initial values for EC and CH versions.
*4 SN represents "SNVT" (Standard network variables) and SC represents "SCPT" (configuration property).
51 SC
Reference frequency setting
(0.1Hz/bit)
*1
SNVT_freq_hz nciNmlFreq
In Pr. 390 2
60Hz
<50Hz>
* 3
101
52 SC Speed adjustment default value
SNVT_lev_percent nciDrvSpeedScale
In  2 100.00% 101
53 SC
Event driven detection width
(0.005%/bit)
SNVT_lev_percent nciInvEvtDuty
In Pr. 392 20%102
54 SN
Cumulative power monitor 2
(0.1kWh/bit)
SNVT_elec_kwh_l nvoDrvRunPower_l
Out
EEPROM of
the inverter
40kWh61
55
to
62
System reserved
REMARKS
• Write conditions of configuration property is same as those of the inverter parameter. Write conditions are restricted
by Pr. 77 Parameter write selection. When writing to configuration property during inverter operation, set "2" in Pr. 77.
Refer to the inverter manual for details of Pr. 77.
No.
Type
*4
Function
Network Variables
In/
Out
Setting Value
Storage
Location
Size
(byte)
Initial
Value
Refer
to
Page
Variables Name