Instruction manual

47
6
NETWORK VARIABLES
6.3.3 Object status (network output SNVT_obj_status nvoStatus)
You can indicate the condition of the node.
* "0" is always set in the unsupported functions bit position.
Member Name Description Initial Value
object_id The setting value of object request (nviRequest) written to object_id is displayed.
H0
invalid_id
Changes to "1" if an illegal object ID is specified in object_id of the object request
(nviRequest),
invalid_request Changes to "1" if object_request not supported by the object request (nviRequest) is set.
disabled Changes to "1" if the object of the inverter is invalid.
out_of_limits
Not supported.*
open_circuit
out_of_service
Mechanical_fault
feedback_failure
over_range
under_range
electrical_fault
unable_to_measure
comm_failure
fail_self_test
self_test_in_progress
locked_out
manual_control
Changes to "1" if the operation mode of the inverter is other than the network operation
mode.
in_alarm Changes to "1" during the inverter is in the alarm status.
in_override
Changes to "1" if the operation mode of the inverter is network operation mode and run
command and speed command are not given via the network.
report_mask
Not supported.*
programming_mode
programming_fail
alarm_notify_disabled