Instruction manual

83
6
NETWORK VARIABLES
6.8 Configuration Properties
6.8.1 Initial communication delay time (network input config SNVT_time_sec
nciPwUpOutTm)
You can set the time from when the inverter starts until when data is sent to LONWORKS at power-on or
inverter reset.
⋅ Data acceptance timing........... At network variable receive (nv_update_occurs event)
REMARKS
• The parameter setting is made valid at power-on or inverter reset.
• The delay time at power-on and inverter reset is set and this setting does not affect normal data transmission.
Data Name Initial Value Range Increments
nciPwUpOutTm
0s 0.0s to 120.0s 0.1s/bit
Parameter Name
387 Initial communication delay time