Instruction manual

86
NETWORK VARIABLES
6.8.4 Maximum frequency (0.1Hz increments) (network input config
SNVT_freq_hz nciInvMaxFreq)
You can set the maximum frequency to be output by the motor to the inverter in 0.1Hz increments.
⋅ Data acceptance timing........... At network variable receive (nv_update_occurs event))
6.8.5 Minimum frequency (0.1Hz increments) (network input config
SNVT_freq_hz nciInvMinFreq)
You can set the minimum frequency to be output by the motor to the inverter in 0.1Hz increments.
⋅ Data acceptance timing........... At network variable receive (nv_update_occurs event)
Data Name Initial Value Range Increments
Setting Value
Storage Location
nciInvMaxFreq Initial value of Pr. 1 0.0Hz to 400.0Hz 0.1Hz/bit Pr.1/Pr.18
REMARKS
• Refer to the inverter manual for details of Pr. 1, Pr.18.
Data Name Initial Value Range Increments
Setting Value
Storage Location
nciInvMinFreq Initial value of Pr.2 0.0Hz to 120.0Hz 0.1Hz/bit Pr.2
REMARKS
• Refer to the inverter manual for details of Pr. 2.