Instruction manual

32
Names and functions of the control panel
3.3.7 Copy mode
By using the control panel (FR-DU04-1), the parameter values can be copied to another inverter (only the FR-V500
series).
1) Operating procedure
After reading the parameter values from the copy source inverter, connect the control panel to the copy
destination inverter, and write the parameter values.
After writing the parameter values to the copy destination inverter, always reset the inverter, e.g. switch power
off once, before starting operation.
Reference: It is recommended to perform parameter read after completion of parameter setting. (When
performing auto tuning, it is recommended to perform read after completion of auto tuning.) When the
inverter has been changed, performing parameter write from the control panel fitted to a new inverter
completes parameter setup.
CAUTION
1. While the copy function is being activated, the monitor display flickers. The display returns to the lit-
up state on completion of the copy function.
2. If a read error occurs during parameter read, "read error (E.rE1)" is displayed.
3. If a write error occurs during parameter write, "write error (E.rE2)" is displayed.
4. If a data discrepancy occurs during parameter verify, the corresponding parameter number and
"verify error (E.rE3)" are displayed alternately. If the directly preset speed or jog speed setting differs,
"verify error (E.rE3)" flickers. Press to ignore this display and continue verify.
5. When the copy destination inverter is not the FR-V500, "model error (E.rE4)" is displayed.
FR-DU04-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
FR-DU04-1
CONTROL PANEL
Hz/r
MON EXT PU
A
V
REV FWD
SET SET SET
(Caution 1)
SET
Connect to copy destination inverter.
Press for
1.5s
After writing the parameter values,
always reset the inverter prior to
the start of operation.
Parameter setting mode
Parameter read Parameter write Parameter verify
Press for
1.5s
Press for
1.5s
(Caution 1) (Caution 1)
SET