Instruction manual

5
Structure
OUTLINE
1
1.2.2 Removal and reinstallation of the control panel
To ensure safety, remove and reinstall the control panel after powering off.
REMARKS
• Removal of the wiring port cover for option (DATA PORT)
Push the DATA PORT from the back of the front cover to
remove before fitting the communication option.
z Removal
Hold down the top button of the control panel and pull the control panel toward you to remove.
When reinstalling the control panel, insert it straight and reinstall it securely.
z Reinstallation using the connection cable
1) Remove the control panel.
2) Disconnect the modular jack type relay connector. (Place the disconnected modular jack type relay
connector in the modular jack type relay connector compartment.)
3) Securely plug one end of the connection cable into the PU connector of the inverter and the other end into
the control panel. (Refer to page 19 for the connection cable.)
CAUTION
Install the control panel only when the front cover is on the inverter.
W
iring port cover
f
or option
(DATA PORT)
.
Removal
Reinstallation
Modular jack type
relay connector
Modular jack type
relay connector compartment