Instruction manual

84
Correspondences between digital
and actual characters
6.2 Correspondences between digital and actual characters
There are the following correspondences between the actual alphanumeric characters and the digital characters
displayed on the control panel.
6.3 Resetting the inverter
The inverter can be reset by performing any of the following operations. Note that the internal thermal integrated
value of the electronic thermal relay function and the number of retries are cleared (erased) by resetting the inverter.
Recover about 1s after reset is cancelled.
Operation 1: Using the control panel, press to reset the inverter.
(Enabled only when the inverter protective function (major fault) is activated. (Refer to page 74 for
major faults.))
Operation 2: Switch power off once, then switch it on again.
Operation 3: Turn on the reset signal (RES) for more than 0.1s.
Actual Digital
0
1
2
3
4
5
6
7
8
9
Actual Digital
A
B
C
E
F
G
H
I
J
L
D
Actual Digital
M
N
O
o
P
T
U
V
r
S
STOP
RESET