Installation manual

English
− NA - 8 −
3
Installation method - continuation
1. Remove the drain tank.
Drain tank
5. Remove the terminal block cover
mounting screw (1), and remove the
terminal block cover.
※ Be careful not to lose the cord bushing.
Base
Cord bushing
Terminal block cover
Terminal
block cover
mounting
screw
2. Open the front cover and remove the
air fi lter.
※ Refer to "How to open/close the front cover"
(Page 13).
Air fi lter
Air fi lter
Open
Main unit
panel
Pull the tab and open the front
cover.
Tab
3. Remove the main unit panel
mounting screw (1).
4. Unlock the upper tabs (2 locations)
of the main unit panel, and remove
the main unit panel from the base.
Main unit panel
mounting screw
Main
unit panel
Base
Main unit panel
Tab
Base
Pull the tab and open the front
cover.
Tab
Front cover
4
1. Push the power cable for exclusive
wiring through the power cord hole
at the rear of the base.
2. Engage the base with the 2 hooks on
the installation panel.
3. Check that the power cable is not
trapped behind the base.
Base
Ground wire
Power cord hole
Power cord hole
Power cable
Power cable
Ground wire
Installation
panel
Panel hooks
(2 locations)