Instruction manual

10
Room temperature may rise
2-4°C during operation
The dehumidifier does not have a cooler function.
Due to heat produced during operation, the room
temperature may rise 2-4°C. As a result, the unit
may blow warm air, but this is not due to a
malfunction.During winter, the air may not feel warm
as the temperature is below body temperature.
The humidity reading on the
unit may differ from a
hygrometer in the same room
Even in the same room, temperature and humidity
levels may differ from place to place. If the
hygrometer and the unit are in different parts of the
room, the humidity levels are prone to differ.
Moreover, humidity levels differ between places
that have good and no airflow.
Use the reading on the unit as an estimate.
Things to be aware of Before using your
How does the dehumidifier
work?
If you pour cold water into a cup, the air around
it becomes cold, causing water droplets to form
on the surface of the cup.
The dehumidifier takes advantage of this
phenomenon to remove moisture from the air.
1 The unit draws air from the room, cools it with
its cooling coil, causing the moisture to
transform into water droplets.
2 The water droplets fall into the water tank.
3 The dehumidified air is reheated by the
heating coil, and then discharged.
The humidity of the room is thus reduced by
repeating steps 1, 2, and 3.
Re-heating coil
Cooling coil
Moist air
Compressor
Dried (warm) air
Water tank
1
2
3
W
h
y
a
r
e
t
h
e
y
d
i
f
f
e
r
e
n
t
?
CURRENT
<Cause>
● Inconsistencies
in temperature
and humidity
● Difference in
location
● Difference in
hygrometer
precision
Fitting the
photocatalytic filter
The photocatalytic filter is supplied with
the unit at time of purchase. Fit before
using the unit.
1 Remove the photocatalytic filter
from the polyethylene bag.
2 Remove the front panel and pre-
filter.
3 Fit the photocatalytic filter into
the pre-filter.
With the strips facing up, set the
photocatalytic filter inside the tabs on
the pre-filter.
4 Attach the pre-filter and front
panel.
Front panel
Pre-filter
1 Remove holding
the bottom.
2 Remove
holding the
tabs.
Performance is unaffected even if
the metal fins inside the main unit
are slightly bent.
Tabs (6)
Strips
1 Attach holding the
tabs.
2 Hook the top edge to
the top part of the unit
and push the bottom in.
e_mj_e22vx_a1(01_19)_e33.qx 11/25/04 12:53 PM Page 10