Instruction manual

2424
Maintenance (Continued)
Once every three months
Photocatalytic filter
Soaking the filter in water, and leaving it to dry in the sun
renews the performance and prolongs service life. Perform
this every three months.
1 Remove the front panel and pre-
filter.
2 Remove the photocatalytic filter.
3 Soak the photocatalytic filter in
water.
¡ Stains may remain on the filter, but should not
affect performance.
¡ The filter can be soaked for a total of eight
times.
After that, replace with a new filter.
4 Dry the photocatalytic filter.
Dry well in the sun (The
performance of the filter
renews with soaking, and
the photocatalytic effect
of the sunlight removes
remaining odorants)
5 Fit the photocatalytic filter.
With the strips facing up, set the
photocatalytic filter inside the tabs on
the pre-filter.
6 Attach the pre-filter and front
panel.
Soak in cool to
lukewarm water for
30 minutes.
Do not use detergent or hot water.
Also, do not brush or rub while
soaking as this may damage the filter.
Do not hang with pegs as this may
damage the filter.
Do not use the filter while wet.
1 Remove holding
the bottom.
1 Attach holding the
tabs.
2 Hook the top edge
to the top part of the
unit and push the
bottom in.
2 Remove
holding the
tabs.
Performance is
unaffected even if the
metal fins inside the main
unit are slightly bent.
Front panel
Photocatalytic
filter
Tabs (6)
Pre-filter
Pre-filter
e_mj_e22vx_a1(20_28)_e33.qx 11/15/04 5:17 PM Page 24