Installation manual
- 13 -
7 Attach the controller to the A type installation plate with the
M4 roundhead screws (supplied).
8 Replace the AG-150A surface cover.
2-2. Wall-Embedded installation with an Electric box (PAC-YG83UTB; sold separately)
1 Ensure there is enough space to install the controller as shown below. Wall space (see diagram below) and 60 mm (2-
3
/
8
in) of
clearance behind the wall are required to mount an Electric box.
2 Punch out the appropriate knockout holes on the Electric box depending on how the cable is routed.
3 Install the Electric box in the wall.
Refer to the Installation Manual that came with the Electric box (PAC-YG83UTB) for details.
NOTES
* When installing two or more controllers side-by-side and horizontally ensure that there is at least 130 mm (5-
1
/
8
in) or more
between the units.
* When installing two or more controllers vertically, ensure that there is at least 150 mm (5-
15
/
16
in) between units; otherwise, it will
be hard to remove the cover.
* The amount of space required on the left of the controller is the amount necessary to connect/disconnect the USB drive. (If the
specified amount of space is not available, use a USB extension cable.)
* The amount of space required under the controller is the amount necessary for the mounting/dismounting of the controller
cover.
M4 roundhead
screw (supplied)
A type Installation plate
(supplied)
300 (11-
13
/
16
)
185 (7-
5
/
16
)
120 (4-
3
/
4
)
100 (3-
15
/
16
)
30 (1-
3
/
16
)
30 (1-
3
/
16
)
Electric box (PAC-YG83UTB; sold separately)
Inner wall
AG-150A
Building structure
60 mm
(2-
3
/
8
in)
minimum
Unit: mm (in)
AG-150A
Punch out the knockout holes.
(Punch out the appropriate
knockout hole.)
WT05368X08.fm Page 13 Thursday, March 17, 2011 9:21 AM