Installation manual

- 15 -
9 Attach the controller to the A type installation plate with the roundhead screws (supplied).
0 Replace the AG-150A surface cover.
2-3. Wall-mounting the centralized controller with the mounting attachment B type
(PAC-YG81TB; sold separately)
1 Ensure there is enough space to install the controller as
shown in the figure at right.
NOTES
* When installing two or more controllers side-by-side and horizontally ensure that there is at least 130 mm (5-
1
/
8
in) or more
between the units.
* When installing two or more controllers vertically, ensure that there is at least 150 mm (5-
15
/
16
in) between units; otherwise, it will
be hard to remove the cover.
* The amount of space required on the left of the controller is the amount necessary to connect/disconnect the USB drive. (If the
specified amount of space is not available, use a USB extension cable.)
* The amount of space required under the controller is the amount necessary for the mounting/dismounting of the controller
cover.
Back of controller
M-NET transmission cable
DC power cable
* When using bridge wiring of the shield,
use the S-terminal as shown below.
M-NET transmission cable
DC power cable
shield
S
A
B
Function earthing
(ground) cable
* When a PAC-YG50ECA Expansion controller is used,
the M-NET terminals will not be used.
M4 rounded screw
(supplied)
Wall
Unit: mm (in)
Mounting attachment
B type
(PAC-YG81TB; sold
separately)
30 (1-
3
/
16
)
100 (3-
15
/
16
)
300 (11-
13
/
16
)
120 (4-
3
/
4
)
30 (1-
3
/
16
)
185 (7-
5
/
16
)
WT05368X08.fm Page 15 Thursday, March 17, 2011 9:21 AM