Installation manual
- 20 -
7 Screw down the A type installation plate (supplied) on the
control board door with the M4 flathead screws (supplied).
Drill four screw holes and a 278 mm [W] × 152 mm [H] hole
on the control board door ahead of time.
(Cut screw threads in the control board screw holes, or use
nuts to tighten screws.
Use the B type installation plate (supplied) if the above is not
feasible.
Refer to section 2-14.)
8 Remove the AG-150A surface cover.
9 Install the AG-150A on the A type installation plate with the
M4 roundhead screws (supplied).
0 Replace the AG-150A surface cover.
a Connect the power supply unit and centralized controller.
NOTE
* When using an LAN and external signal
I/O, refer to section
11 External input/output usage .
Unit: mm (in)
Control board
A-type installation
plate (supplied)
M4 flathead screw
(supplied)
278 (10-
15
/
16
)
200 (7-
7
/
8
)
152 (6)
163.4 (6-
7
/
16
)
φ
4 or above
M4 roundhead screw
(supplied)
WT05368X08.fm Page 20 Thursday, March 17, 2011 9:21 AM