Operation Manual

En-4
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low.
In about 7 days after the indicator starts lights up, the remote controller stops
working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Before operation: Insert the power supply plug into the power outlet and/or
turn the breaker on.
Installing the remote controller batteries
PREPARATION BEFORE OPERATION
• Press CLOCK gently using a thin instrument.
Setting current time
Changing temperature units (˚F→˚C)
Unit is preset with °F.
1.
Press RESET while
the temperature but-
tons are pressed.
• Press RESET gently using a thin instrument.
• To change temperature unit from °C to °F, press RESET.
RESET
CLOCK
1.
Remove the front lid.
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
3.
Install the front lid.
4.
Press RESET.
RESET
CLOCK
1.
Press CLOCK.
3.
Press CLOCK again.
2.
Press the TIME buttons to set
the time.
Each press increases/decreases
the time by 1 minute (10 min-
utes when pressed longer).
JG79Y039H02_en.indd 4 11/18/2016 5:46:47 PM