Manual

Part II1: Setup
Programming the Remote Control: To Control Other A/V Products
[]
©ABL_DBS
TV
POWER
E
DVD/LDP brand Codeto enter:
Mitsubishi (DVD) 003
Mitsubishi (LDP) 016,017
Panasonic 250
Pioneer DVD (LDP) 252 (016, 017)
Sony 254
Toshiba 253
To reset to default code, enter 000
If your
DVD
code Jsnot
listed here,
please see
page 62
fora
complete
listing,
Figure 4. Programming the remote to control your DVD/
LDP.
E
After entering the correct codes for each
position of the remote control, use the slide
switch to select the product to control when
an operational button is pressed. If you
enter a code from the AUDIO chart while
the slide switch is set to TV, the volume
and mute functions change to match the A/V
receiver. This is useful when using an A/V
receiver with the TV all the time. In all
other cases, only one of the below devices
is allowed for each slide switch position.
TV_position:
_TV
[] A/V receiver (volume and mute only)
Cable/DBS position:
[] Cable box
[] Satellite receiver
CABL_DBS
TV
POWER
Audio brand
Mitsubishi AN receiver
and/or CD player
Denon
Kenweod
JVC
Onkyo
Pioneer
Sony
Yamaha
Code _ e_er:
S_ _VRIO00 or M-VRS00 to 015
S_ _VRg00 or M_RTO0 _ 010
234,235,236
200,206
232,233
209,214
205,207
222
201,206
To reset to default code, enter 000
If your
audio
code is not
listed here,
please see
page 62
fora
complete
listing,
VCR position:
[] VCR
DVD position:
[] DVD
[] LD Player
Audio position:
[] A/V receiver
[] Mitsubishi CD player [if youhavea MitsubishiA/V
receiver, the audio position may be used in conjunction with
select Mitsubishi CD players. Your audio position must be
programmed to either 010 or 011. Plug the CD player power
cord into a switched outlet on the back of your A/V receiver.
Pressing the POWER button will then turn on your A/V receiver,
in turn, turning on your CD player. On select CD players, the
transport controls (FF, Play, Rew, etc.) in the audio position will
operate the CD player.]
Figure 5. Programming the remote to control your A/V
receiver.