Instructions / Assembly
Table Of Contents
- ,H185101,
- GENERAL
- INSTALLATION
- STEP 1. Pull the wires out from the outlet box, and install mounting plate onto the outlet box using the (2) mounting screws.
- STEP 2. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
- STEP 3. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
- STEP 4. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
- FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SEROIUS INJURY OR DEATH!
- STEP 5. Carefully place connections back into the outlet box
- STEP 6. Attach the bottom mounting plate on the wall then secure it with the wall anchor and wood screw.
- STEP 7. Place Back plate over the mounting plate and secure with set screws.
- STEP 8. Place bottom back plate over the bottom mounting plate and secure with hexagon screw using hexagon spanner.
- STEP 9. Install the lamp. The fixture is rated for 75 watt type T lamp.
- DO NOT EXCEED RECOMMENDED WATTAGE!
- STEP 10. Restore power to the circuit at breaker or fuse box.
- DIMMING
- CLEANING
- ASSEMBLY AND MOUNTING DIAGRAM
- WIRE NUT/TAPING DIAGRAM
- H185 101 M41
- GENERALITÉ
- INSTALLATION
- PAS 3. Relier le fil neutre (blanc) venant de la base du dispositif au fil neutre (généralement blanc) de la boîte de dérivation. Relier les deux fils entre eux à l’aide d’un serre-câble en plastique et envelopper le serre-câble de ruban isolant bien ...
- RÈGLAGE D’INTENSITÉ
- NETTOYAGE
- SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
- SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
H185101 DYLAN SCONCE
www.hudsonvalleylighting.com/mitzi | #mymitzi
SCHÉMA D’ASSEMBLAGE ET DE MONTAGE
SCHÉMA DE BORNE DE RACCORDEMENT ET D’ENVELOPPAGE AVEC RUBAN ISOLANT
RUBAN ISOLANT
CONNECTEUR APPROVÉ
(BORNE DE RACCORDEMENT)
PLAQUE DE MONTAGE DU BAS
CHENILLE MURALE
PLAQUE ARRIÈRE DU BAS
VIS DE FIXATION
BOÎTE DE
DÉRIVATION
PAROI
VIS DE BOIS
PLAQUE ARRIÈRE
VIS DE MONTAGE
AMPOULE
VIS DE MISE À TERRE
PLAQUE DE MONTAGE
VIS À SIX PANS
CLÉ À SIX PANS