Instructions / Assembly

H261806, H261810, BRIGITTE CHANDELIER
www.hudsonvalleylighting.com/mitzi| #mymitzi
ASSEMBLY AND MOUNTING INSTRUCTIONS
GENERAL
• WARNING-DISCONNECT POWER BEFORE RELAMPING OR
WIRING THE FIXTURE. TURN OFF THE ENTIRE ELECTRICAL
CIRCUIT TO WHICH THE LIGHTING FIXTURE IS ATTACHED
• INSTALLATION AND MAINTENANCE OF THIS FIXTURE
SHOULD BE COMPLETED BY A LICENSED ELECTRICAN
• FAILURE TO INSTALL FIXTURE CORRECTLY COULD RESULT IN
SERIOUS INJURY OR DEATH
• READ ALL INSTRUCTIONS BEFORE STARTING INSTALLATION.
• IF AN EXISTING FIXTURE IS BEING REPLACED, REMOVE IT AND
NOTE TO WHICH WIRE IN THE OUTLET BOX THE ORIGINAL
FIXTURE WAS ATTACHED.
• BEFORE DISCARDING THE CARTON DOUBLE CHECK THE
PACKAGING TO MAKE SURE ALL PARTS HAVE BEEN FOUND.
• THIS FIXTURE WAS DESIGNED TO BE MOUNTED TO AN
OCTAGON OUTLET BOX. THE BOX MUST BE SECURELY
MOUNTED TO THE STRUCTURE OF THE BUILDING.
INSTALLATION
STEP 1. Pull the wires out from the outlet box, and install
mounting plate onto the outlet box using the (2)
mounting screws. Strip the fixture wires ½” long at the
ends.
STEP 2. Adjust the arms of fixture .The arms should be positioned
with equal distances between them.
STEP 3. Choose the length of the chain you need, then weave the
fixture wire and the fixture grounding wire through the
chain. Connect one end of the chain with the loop.
STEP 4. Secure the screw collar loop to nipple.
STEP 5. Thread the fixture wire and fixture grounding wire
through the loop ring, canopy, screw collar loop, nipple
and mounting plate.
STEP 6. Connect the other end of the chain with screw collar loop.
STEP 7. Fasten bare ground wire to ground wire from the wall
outlet box (usually green or copper color) or connect
ground wire to green screw on the mounting plate.
STEP 8.
STEP 9.
STEP 10.
STEP 11.
STEP 12.
STEP 13.
Connect the neutral (white) fixture wire coming from the
fixture base to neutral (usually white) outlet wire. Fasten
both wires together with a plastic wire nut and tightly
wrap the wire nut with electrical tape.
Repeat the previous step with the hot (black wires). Make
sure there are no exposed wires or strands that could
cause a dangerous short circuit.
FAILURE TO CONNECT THE APPROPRIATE WIRES
CORRECTLY COULD RESULT IN SERI
OUS INJURY OR
DEATH!
Carefully place connections back into the outlet box.
Mount the canopy to the mounting plate using the loop
ring secure to Screw collar.
Install the lamps. The fixture is rated for 60 watt type B
lamp.
DO NOT EXCEED RECOMMENDED WATTAGE!
Restore power to the circuit at breaker or fuse box.
DIMMING
The fixture can be controlled by a wall dimming device. Only use
triac/electronic dimmer. Make sure carton is marked for use with LED
compact fluorescent-incandescent light source only. These can be
provided by your local electrical distributor, home center, or
hardware store.
CLEANING
Please clean with a soft, dry cloth ONLY! Do not use cleaning products.