User manual

EN
Cleaning and maintenance Mobicool DC
10
6.3 Connecting to the cigarette lighter
I
NOTE
If you connect the cooler to the cigarette lighter, remember that in
most vehicles the ignition must be turned on to supply it with power.
7 Cleaning and maintenance
!
WARNING!
Always disconnect the device from the mains before you clean and
service it.
A
NOTICE! Risk of damage
 Never clean the cooler under running water or in dish water.
 Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
8 Troubleshooting
Problem Possible cause Suggested remedy
Your device is not
working (plug is
inserted).
There is no voltage flowing
from the DC socket (ciga-
rette lighter) in your vehicle.
The ignition must be switched on in
most vehicles to supply current to the
cigarette lighter.
The inner fan or the cooling
element is defective.
This can only be repaired by an
authorised repair centre.
When operating from
the DC socket (ciga-
rette lighter):
The ignition is on and
the cooler is not work-
ing.
The fitting of the DC plug is
dirty. This results in a poor
electrical contact.
If the plug of your cooler becomes very
warm in the DC socket fitting, either the
fitting must be cleaned or the plug has
not been assembled correctly.
The fuse of the DC plug has
blown.
Replace the fuse of the DC plug with
one of the same rating.
The vehicle fuse has blown. Replace the vehicle's DC socket fuse
(usually 15 A). Please refer to the
operating manual of your vehicle.