User manual

EN
Safety instructions Mobicool AC/DC
6
A
NOTICE!
 Check that the voltage specification on the type plate
corresponds to that of the energy supply.
 Only connect the device as follows:
– With the DC cable to a DC plug socket in the vehicle (e. g.
cigarette lighter)
– Or with the 230 V connection cable to the 230 V AC mains
supply
 Never pull the plug out of the socket by the cable.
 If the cooler is connected to the DC socket: Disconnect the
cooler and other power consuming devices from the battery
before connecting the quick charging device.
 If the cooler is connected to the DC socket: Disconnect the
cooler or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
 The cooling device is not suitable for transporting caustic
materials or materials containing solvents.
 The cooling device contains inflammable cyclopentane in the
insulation. The gases in the insulation material require special
disposal procedures. Deliver the device at the end of its life-
cycle to an appropriate recycling.
2.2 Operating the device safely
D
DANGER!
 Do not touch exposed cables with your bare hands. This
especially applies when operating the device with an AC mains
power supply.
!
CAUTION!
 Before starting the device, ensure that the power supply line
and the plug are dry.
A
NOTICE!
 Do not use electrical devices inside the cooler unless they are
recommended by the manufacturer for the purpose.
 Do not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).