User manual

Cleaning and maintenance Mobicool DC
10
7 Cleaning and maintenance
!
WARNING!
Always disconnect the device from the mains before you clean and
service it.
A
NOTICE! Risk of damage
z Never clean the cooler under running water or in dish water.
z Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
8 Troubleshooting
9 Disposal
➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
M
If you wish to finally dispose of the device, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
10 Technical data
Technical data can be found on the type plate.
Problem Possible cause Suggested remedy
Your device is not
working (plug is
inserted).
There is no voltage flowing
from the DC socket (ciga-
rette lighter) in your vehicle.
The ignition must be switched on in
most vehicles to supply current to the
cigarette lighter.
The inner fan or the cooling
element is defective.
This can only be repaired by an
authorised repair centre.
When operating from
the DC socket (ciga-
rette lighter):
The ignition is on and
the cooler is not work-
ing.
The fuse of the DC plug is
dirty. This results in a poor
electrical contact.
If the plug of your cooler becomes very
warm in the DC socket fitting, either the
fitting must be cleaned or the plug has
not been assembled correctly.
The fuse of the DC plug has
blown.
Replace the fuse of the DC plug with
one of the same rating.
The vehicle fuse has blown. Replace the vehicle's DC socket fuse
(usually 15 A). Please refer to the
operating manual of your vehicle.
_Mobicool.book Seite 10 Dienstag, 14. September 2010 8:29 08