Use and Care Manual

6
The AC CHARGING ADAPTER complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
USING THE DC VEHICLE CHARGING ADAPTER
1. Plug the DC Vehicle charger jack into the charging port on the bottom of
the light next to the charging indicator LED.
2. Plug the other end of the DC adapter into the vehicle’s 12V DC cigarette
lighter or accessory power socket
3. The charging indicator light will glow RED while charging is in progress.
4. The battery will be fully charged after approximately 8 to 10 hours
and the RED charging indicator light will turn GREEN when the unit is
fully charged.
5. Disconnect the DC vehicle charger from the light first and then the other
end from the 12V power outlet.
NOTE: SOME VEHICLES REQUIRE THE KEY TO BE ON ACC POSITION TO
ACTIVATE THE 12V DC ACCESSORY OUTLET.
TO PREVENT OVERCHARGING DO NOT CHARGE FOR MORE THAN 8
HOURS CONTINUOUSLY.
SAFETY PRECAUTIONS
The DC charging adapter can be used in most vehicles by plugging into the
12V DC cigarette lighter or accessory power socket.
Store in dry location and do not allow the charging adapter to come in
contact with water, rain or snow.
If the charging adapter comes in contact with water, place in a dry location at
room temperature, on a soft absorbent towel and allow to dry thoroughly.
Do not operate the unit until is completely free of moisture.
Use only the DC charging adapter supplied with the light. Do not attempt to
charge the light with an adapter that is not compatible as this could result in
a fire, damage to the light or personal injury.
CARE AND MAINTENANCE STORAGE
Store the multifunctional LED light and charging adapters in a clean and
dry area. Be sure to keep the charging adapters supplied with this product
stored separately from similar items as only charging adapters included
with this light are compatible. Using an non-compatible charger could
cause damage to the light and / or personal injury.
The Multifunctional LED light may also be store in a vehicle for use in
roadside emergencies. To prevent light and any other accessories being
damaged, ensure that it is properly secured and in a safe place inside the
vehicle.