User guide

IG7600 Administration Manual

 Each message can be saved for 1 - 30 days or permanently.

 Support 50 Virtual Mailboxes

 Enter voicemail through another phone extension

• Management Menu

 Change the Greeting Mode: Working, Holiday, and Temporary.

 Record the Greeting Messages

 Record other voice prompts.

• Voice Messages

 Provide two languages service for the all voice files.

 Support G711-ulaw, G711-alaw, G729 three voice files.

 Administrators can record the all voice messages by themselves.

 Administrators can update, backup or delete the all voice messages from/to

the PC.

For the detail, please refer Appendix 3.

NOTE: When an extension’s voicemail is filled up to more than 100 mails, VM

system will just read “You have 99 mails.”

3.5 Auto Provisioning

WAN Management Protocol (TR-069) allows an Auto-Configuration Server (ACS) to

perform auto-configuration, provision, collection, and diagnostics to this device. Firmware

upgrade or vendor configuration file backup can be done remotely on ACS server. Select

the desired values and click "Save Settings" to configure the TR-069 client options.

An Auto Provision Server (APS) is also provided to update IG7600 FW, Update / Retrieve

IG7600 Configuration and the registered IP2061/M22/M62 firmware, Management->PTC

page is used to configure IG7600 to communicate with APS Server.

3.6 Basic Call

To make an intercom call, dial a Station number (IP Terminal, POTS) or a Voice Mail

number.

To make an outside call, dial a phone number. IG7600 chooses a line (PSTN line, IP

trunk, another IG7600) via Call Routing Table to dial out.

To make an outside call, dial a PSTN, an IP Trunk or a Trunk Group number first. After

hearing dial tone, dial the phone number.

3.7 Call Abandon

For every PSTN call, IG7600 provides the facility to monitor the call status. If the remote

party hangs up, the ongoing call will be terminated.

The PSTN line monitor is accomplished through monitoring the loop-break signal, polarity

reversal or busy tone. The value range of loop-break signal is: “Disable”/100/200/…/1000

ms.