User guide

IG7600 Administration Manual

by inputting the Trunk Access Code 701. Meanwhile, other extensions can also pick

up this trunk call by pressing the IDLE Individual Call Park key and input the extension

number “101”.

4.11 Call Pickup – Individual

You may answer the calls at another specified extension. The feature allows you to easily

access calls ringing via the feature access code.

*53 + Extension Number

4.12 Call Waiting

If Call Waiting is enabled for a specific IP2061/M22/M62/M54(-i) station, an alert (muted

ring) will be played on the called party when a second call is received and the extension is

in use.

To enable Call Waiting, dial *98

If Call Waiting is disabled for a specific station, the station will return a busy tone to any

calling party while the station is in use.

To disable Call Waiting, dial **98

PS: Call waiting is disabled by default. You have to enable it manually.

Call waiting tone is enabled by default.

4.13 Caller Blocking

IP2061/M22/M62 can block up to 10 phone numbers from reaching you at your phone

when a caller attempts to call you from one of these numbers.

4.14 CO Flash

FXO Line is programmed setting that will determine what flash timing will be presented to

the CO/PBX when the extension issues a Hook-Flash command while connected to a

FXO Line.

4.15 COS Following

You can temporarily change the individual Class of Service of each extension on a per

call basis. You may want to do this when the user goes to the office of low-priority COS

extension and try to make an outgoing call, the user can use the function to use their own

COS.

When using the COS Following feature the station COS change will revert to the station’s

original COS after a one minute idle time-out.

To set COS Following, dial *55 + (phone number) + (password)

4.16 Distinctive Ringing

Distinctive ring cadences can be selected allowing adjacent users to discern which

extension is ringing. It also provides different ring tones for intercom and trunk calls.

Every Trunk Line may be allocated one of the available Ring Types. When the feature is

used, the specific ring type assigned to the Trunk Line is the ring type heard when the

Trunk Line rings. The feature helps to identify the Trunk Line and the Trunk Group to

which it belongs to.