User guide

IG7600 Administration Manual

6.4 Advanced Setup

Advanced Setup allows system administrator to configure the following topics:

 WAN

 LAN

 NAT

- Virtual Servers

- Port Triggering

- DMZ Host

 Security

- IP Filtering

 Outgoing

 Incoming

 Parental Control

- Time Restriction

- URL Filter

 Quality of Service

- DSCP Marking

- Bandwidth Control

 Routing

- Static Route

 Dynamic DNS

 Upnp

6.4.1 WAN

There are three modes that you can give WAN IP address to IG7600: Static IP mode,

DHCP mode and PPPoE mode. You can also enable or disable Firewall.

Network Address Translation (NAT) allows you to share one public WAN IP address for

multiple computers on your LAN side. In IG7600, NAT is enabled by default and is not

shown on the page to prevent it from being disabled.

This page shows the setting of WAN interface which is Static IP mode (Figure 6-8).

Figure 6-8. Advanced – WAN (Static IP Mode)