User guide

Page 16
MOCET IP3092/IP3092L Communicator User Guide
1.6. Communicator LED Function Description
The Communicator supports two audio system control modes, one is iPad app mode and
the other is Commander mode. Each uses the LEDs in a slightly different manner; and
they are described below.
1.6.1. Communicator LED Functions for IP Commander Mode:
The following table describes all functions of LED indicators:
LED Color Status Description
Off No new messages
Steady
The Communicator is booting or updating
Message Waiting
Indicator
Blue
Blinking slow New voice message indication. This is
also applicable for supported instant
messaging and email apps
Steady Warning: Wired Ethernet link is
disconnected, VoIP service is unavailable,
or Ethernet keep alive link is failing
Fast Flashing Urgent call ringing (for supported servers)
Red
Off N/A
Steady Wide-band audio call support after boot
up.
Blinking N/A
Handset
Blue
Off Narrowband audio call
Off No new messages
Steady On Commander app running on Communicator
Flashing 3 sec. iPad inserted or removed
Home
Blue
Off Commander app not running on foreground,
or Communicator off
Speakerphone
Blue
Blue-green LED indicates that speakerphone is enabled
Mute
Blue
Blue-green LED indicates that “Voice Mute” is enabled
Headset
Blue
Blue-green LED indicates that the headset feature is
enabled
Hotline
Red
By default, the red LED is off. When user makes an
emergency call, the LED will light up. There are two states
where the LED lights up:
(1) Flashing : when the call is dialed and ringing to the
destination.
(2) Steady on: when the call is connected.
Note: To activate the Hotline function, please configure it in the IP Commander
TM
app or
web user interface of the Communicator
TM
. The location address of Communicator
and up to 3 emergency phone numbers may be programmed. For instance,