user manual

CiM-25/600L IP Enabled M&C Rev. 1
SNMP Interface CD/CIM25600L.IOM
115
Description
Unit Faults. Where response is abcd.
a = Unit faults
0 = No faults
1 = Power supply fault, +5 volts
2 = Power supply fault, +12 volts
3 = Power supply fault, -5 volts
4 = Power supply fault, +18 volts
5 = Power supply fault, -12 volts
6 = RAM load fail
7 = Tx synthesizer lock
8 = Rx synthesizer
9 = Power cal Checksum error
A = FPGA main chain load fail
B = Turbo FPGA load fail
C = Modem card FPGA load
D = MUX FPGA load
E = Demux FPGA load
b = Tx Traffic status
0 = Tx traffic OK
1 = No clock from terrestrial interface
2 = Tx FIFO slip
3 = AIS detected on incoming data
4 = AUPC upper limit reached
5 = Ref PLL
6 = BUC current
7 = BUC voltage
8 = BUC checksum
9 = BUC PLL
A = BUC temperature
c = Rx Traffic status
0 = Rx Traffic OK
1 = Demodulator unlocked
2 = AGC Alarm - signal out of range
3 = Demux
4 = Spare
5 = Buffer Slip
6 = AIS detected on incoming data
7 = Eb/No alarm
8 = Buffer Clock activity
9 = LNB current
A = LNB voltage