Installation Sheet

10
11
The ON/OFF switch on the bottom of your wall control (transmitter) terminates
power to the fan. This switch must be in the “ON” position for your fan to receive
commands and to operate. Alternatively, you may use an on/off toggle switch at
the wall box in combination with a remote control handset (transmitter). In some
cases, when no switch leg is present, your fan may have continuous power to the
receiving unit.
Your fan has six speeds, each of which can be selected by pressing the SPEED+
or SPEED- buttons on the wall control or the remote handset. The fan will start
at speed 1 (slowest) and the receiving unit will provide audible feedback
(using short “chirps” and longer “beeps”) to indicate speed progression as follows:
Fan Operation
Fan Installation (continued)
The REV button can be used to change the direction of the fan for summer or
winter operation. Allow adequate time for the fan to come to a complete stop and
then restart in the opposite direction. The fan will return to the same speed at which
it was operating prior to the REV button being used. Alternatively, you can leave
your fan in the summer (downward) airflow setting and simply set it to a low speed
for winter use. This method will also achieve effective destratification (recirculation)
of warmer air trapped at the ceiling level.
The LIGHT button turns the light on and off with each contact. If dimming is
enabled, pressing and holding the light button will achieve continuous dimming
(cycling all the way down then all the way back up) until you release the LIGHT
button. The top and bottom of the dimming range are indicated by an audible
“chirp” from the receiving unit.
If you slide the ON/OFF switch to “OFF”, the fan will return to the same speed and
directional setting (and light setting if an optional light is installed) when you slide
the switch back to the “ON” position. The same memory function will exhibit if you
are using an ON/OFF toggle switch in combination with a handheld remote control
(transmitter).
It is recommended that when the fan is not in use for an extended duration, the ON/
OFF switch on the wall control (transmitter) should be moved to the “OFF” position.
Similarly, if you are using an ON/OFF toggle switch in combination with a handheld
remote control (transmitter), it is recommended that the switch be turned “OFF”
when the fan is not in use for a continuous duration.
1 beep = speed 4
2 beeps = speed 5
3 beeps = speed 6 (fastest)
1 chirp = speed 1 (slowest)
2 chirps = speed 2
3 chirps = speed 3
Audible fan speed indicators: