Installation Guide

FH-W1802Vox Instructions18
5. Finishing the Installation
1. Secure all wire connections with supplied wire ties to assist in
fan installation.
2. Tuck connections neatly into ceiling outlet box.
3. Remove the motor assembly from the hook on the mounting
bracket. Position the motor up to the hanger plate and attach
using two screws through the two key slots in the top of the motor
housing (Fig.5).
NOTE: Make sure the receiver sits at and does not interfere with
the hook.
4. Align the remaining two circular holes on motor housing with the two
holes on the mounting bracket. Secure by tightening the two screws
previously removed. Push the trim ring up to conceal the screws.
1. Insert the blade through the slot in the housing. Align the holes
in the blade with the fan motor assembly holes and secure with
blade attachment screw with lock washers (Fig. 6).
2. Repeat this procedure with the remaining blades (Fig. 6).
1. Remove one of the three mounting plate screws from the
mounting ring and loosen the other two screws (do not remove).
2. Place the key holes in the mounting plate over the two screws
previously loosened from the mounting ring. Turn the mounting
plate until the adapter plate locks in place at the narrow section
of the key holes (Fig. 7).
3. Tighten the two mounting ring screws previously loosened and
the one previously removed to secure adapter plate (Fig. 7).
6. Attaching the Fan Blades
7. Installing the Adapter Plate