Installation Guide

14FH-W1803
9. FINISHING THE INSTALLATION
1. Secure all wire connections with supplied wire ties to assist in
canopy installation.
2. Tuck connections neatly into ceiling outlet box.
3. Slide the motor up to the mounting bracket and place the key
hole on the motor over the screw of the mounting bracket.
Turn canopy until it locks in place at the narrow section of
the key holes.
(Fig. 13)
Note: Make sure the receiver sits at and does not interfere with
the hook.
4. Align the circular hole on canopy with the remaining hole on the
mounting bracket. Secure by tightening the two screws previously
loosened and the two screws previously removed.
5. Raise up trim ring and line up the 4 tabs with the 4 grooves on the
mounting bracket. Once lined up, slide the trim ring and secure it
to the canopy until snug.
FIGURE 13
Motor
Trim Ring
Mounting Bracket
Screws