Installation Guide

8FH-W1803
6. HANGING THE FAN
1. Disconnect power to the fan location. A licensed electrician must
install the fan. (Fig. 4)
2. There are 4 screws on top of motor assembly, remove 2 that are
on the opposite side of each other and save for section 9. Loosen
the remaining 2. (Fig. 5)
3. Pass the 120-volt supply wires through the center hole in the
ceiling mounting plate as shown in Fig. 6.
4. Secure the mounting plate to the ceiling outlet box with the
screws and washers provided with your outlet box. (Fig. 6)
FIGURE 5
FIGURE 4
FIGURE 6
Motor
Assembly
UL/cUL Listed
electrical box
Mounting
plate
Mounting screws
(supplied with
outlet box)
Screws
120V wires
REMEMBER to turn o power at the breaker.
Follow the steps below to hang your fan properly: