Installation Guide

3Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
547 - LED Pendant
PD-54728, PD-54732, PD-54765
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) from the xture.
4. Secure mounting plate to the junction box using junction box screws (B1). The side of the mounting plate marked “GND” must face out.
5. Choose number of rods suitable for your application. Thread the xture wire through the rods, swivel and canopy, connect swivel, rods and
xture body. Make sure all are tightened.
6. Thread the glass onto the xture.
CONNECTING THE WIRES (Fig. 2)
7. Cut the extra wire. Connect the Driver input/output wire with supply wires as shown in Fig. 2, making sure that all
wire connectors (A1) (D1) are secured. If your outlet box has a green or bare copper ground wire, connect the xture’s ground wire to it.
Otherwise, connect the xture’s ground wire directly to the mounting plate using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
8. Place the xture over the mounting back plate and secure with mounting screws (C1).
9. The connection tube can rotate 340 degrees; rotate it to your desired angles.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring