Installation Guide

Slip Fit Spouts

WITH THE "O"-RING SEAL

Lookout must be free from deep scratches, dents, kinks

or bends. The cut-off end must be free from burrs

inside and out. The edge must not be rolled inward

from a dull tubing cutter.

The spouts are specifically designed to permit the

use of copper water tube on drops and lookouts.

FINISHED

WALL LINE

1/2" COPPER WATER TUBE

MT531C MAY 02

Moen Incorporated

Printed in U.S.A.

Turn spout upright into position

against the wall and finish tightening

the clamp screw by hand. The use

of pliers or another wrench on the

hex wrench is not necessary. Do not

overtighten.

CLAMP SCREW

Press and twist the spout onto the

lookout upside down. Tighten the

clamp screw with a 5/32" hex

wrench until it just starts to bind.

MT531C

LOOKOUT LENGTH

(ROUND BASE

SPOUT SHOWN)

1-1/2" MIN.

3" MAX.