Specification Sheet

Paper Holder
posts are die cast from
highest quality zinc alloy (zamac).
Castings are triple plated in a
polished brass, polished chrome or
combination chrome and brass finish.
Roller is plated plastic and spring
loaded.
q
5308PB
–
Paper Holder
Polished Brass Finish
Concealed Screw Mounting
Matching Roller
q 5308CH (BP5308CH) – Paper Holder
Polished Chrome Finish
Concealed Screw Mounting
Matching Roller
q 5308CB (BP5308CB) – Paper Holder
Chrome & Brass Finish
Concealed Screw Mounting
Matching Chrome Roller
“BP” skus in wholesale packaging
Cleaning Instructions:
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 [phone] •
FAX: [phone] • INTERNATIONAL: (440) 962- 2000 •
FAX: (440) 962
-
2726 CUSTOMER SERVICE (USA): 800
-
882
-
0116
1.
Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Place each mounting plate on the template with “UP” facing you.
3. One at a time, place each anchor screw through the mounting plate, centered
in each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall. Do not over
tighten.
4. Only insert screw ½ to ¾ of the way into wall.
5. After all screws are installed, tear the template away from the wall
6. Tighten all 4 screws. Do not over tighten.
7. Position each end post with the setscrew down and place over mounting
plate. Tighten the setscrew at the bottom of each base.
8. Compress the paper holder bar and place into both post holes.
Stock Number:
______________________Paper Holder
By CSI Bath Furnishings
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
5308
Yorkshire Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Copyright CSI Bath Furnishing Division of Moen 02/22/01
Literature #BA1071