Faucet OWNER'S MANUAL 7025, 7030, 7034, 7037 87025, 87030, 87034 Series

5. FOR MODELS WITH SPRAY IN DECK PLATE (30),

install spray hose (26) and spray head (24)

through deck plate hole.

6. TO CONNECT SPRAY HOSE FOR ALL SPRAY

MODELS:

Connect spray hose swivel nut (28) to the

threaded shank (16). Tighten swivel nut by hand

plus 1/4 turn with pliers or channel locks being

careful not to twist the spray hose (26). DO NOT

OVERTIGHTEN.

Flushing is required. See flushing instructions

below.

INS215A

HELPLINE: 1-877-DRINK-H2O

1-877-(374-6542)

LINE FLUSHING INSTRUCTIONS

IMPORTANT: Pipe chips, sand, stones and other solids found in new and

renovated plumbing can damage the sealing surfaces of the filter cartridge and

cause a leak. To avoid damage, DO NOT TURN ON SUPPLY VALVES until

instructed below.

Before you insert the filter and filtering appliance:

1. Turn faucet on in the full cold position (handle

pointing to the right) and allow cold water to flow

for 15 seconds

2. Without turning the faucet off, turn the handle to the full hot position (handle

pointing to the left) and allow hot water to flow for 15 seconds.

3. If side spray is installed, without turning the faucet off, turn the handle to the

mid/mix position (handle pointing toward you) and turn on the spray for 15

seconds.

4. Shut off faucet.

5. You are now ready to insert the filter and filtering appliance.

Sink